The force gage is suitable for panel mounting. This force gage can be used to show the weight, force or torque. The decisive factor here is the type of sensor that is connected to the force gage. The calibration of the force gage to the respective measuring cell is made via the menu with the aid of exact calibration weights. The force gage is used for stationary and individual weighing solutions. Often the force gage is used where the weight has to be determined continuously.
The display of the force gage device is a graphic display, which shows not only the numerical measured value but also the course of the weighing process. The force gage also displays the minimum and maximum weighing values. Using the keys, the force gage can be tared or set to zero. In addition to the operation via the keys, the force gage can be operated via the rear-side digital inputs. So external buttons can be connected, which tare the force display device etc.
Force Gage PCE-N50F
- Up to 1600 Hz sampling rate
- LC display
- Minimum and maximum value determination
- Tare and zero function
- For load cells, force sensors, etc.
- Digital inputs and outputs
Signal Input Range 0 ... 20 mV Minimal sensitivity 0.1 μV / digit Supply voltage of the measuring cell 5V / 100-mA Number of measuring cells 1 ... 8x 350 Ohm measuring cell (s) Display 3.5 "LCD Units g, mN, mlb, Pa, kg, N, Ib, kPa, t, kN, klb, MPa Measuring rate 6, 12, 25, 50, 100, 200, 400, 800, 1600 Hz Electrical connections Screw 1 ... 2.5 mm² Power supply 220V AC / 50Hz Input < 10W Degree of protection Front: IP65 Assembly Panel cut Size panel cutout 152 x 76 mm / 6 x 3 in Dimensions 166 x 88 x 146 mm / 6.5 x 3.5 x 5.7 in Weight About 1150 g / 2.5 lbs Operating conditions -10 ... 40°C / 14 ... 104°F, max 85% RH Storage conditions -20 ... 50°C / -4 ... 122°F, max 85% RH